|
|
|
Pure Stock Rules - 2009
|
|
|
1. Any 1968 or newer American car with a factory wheelbase of at least 101". V-8 Mustangs are O.K. No special order cars.
2. Complete stock body must be retained. NO cutting, chopping, channeling or shortening. All chrome, plastic, and glass must be removed. Dash may be replaced with sheet metal. Steering column must remain stock, may use quick release steering wheel. Hood pins may be used to hold hood in place.
3. Suspension must be completely stock for that make and model. NO racing shocks or air shocks. All front and rear springs must match make and model of car and each other with respect to wire size and height.
4. Engine must be strictly stock for that make and model and in its original mounts. Aluminum intakes on factory original cars must remain unpainted. Repaired engine parts must be approved. NO high performance engines or special order parts. Engines may be over-bored .030, must be stock replacement low compression piston, no flat top 4 eyebrow pistons. Must be dished. Carburetor must be a stock 2 or 4 barrel only. Cam must be stock lift for model with at least 18" vacuum at 1000 RPM. Optional equipment: Engine fan, air breather, ford solenoid, radiator, and fan shroud (can be made from aluminum).
5. Exhaust must be stock cast iron. NO center dump manifolds. NO X pipes. NO H pipes. Straight exhaust pipes only.
6. Transmission must be stock and available in that model. Straight drives must have a stock type clutch, pressure plate, throw-out bearing, and flywheel. Flywheel minimun weight 26 lbs. NO Z-28 flywheels. Automatics may have a cooler mounted in the drivers compartment.
7. Rearend must be stock for that make and model, no gear lower than 3.42. May weld spider gears. Positive traction rear end OK.
8. Tires - Any 70, 75, or 78 series street legal DOT tires. NO truck, mud grips, hi-performance, directional, special order, snow, trick, gumball, fancy or exotic tires of any kind.
9. Wheels must be stock steel, or may run the aftermarket Nomad spoke wheels (wagonwheel style) 7" stock offset only. Large 1" wheel lugnuts may be used.
10. Battery may be moved to inside driver’s compartment. Must be enclosed and securely mounted.
11. Rollcage required must be 4-point with 3 driver side bars and 2 right side bars minimum. NO bars may pass through firewall, front or rear.
12. Fuel cell mandatory (22 gallon max), hole in trunk may have 3" clearance cut around cell. Must have a steel fire wall filling all holes where the back seat was.
13. NO lead or any type of weight may be added to the car.
14. If the car didn’t come with it, you can’t run it. So don’t ask.
15. All safety requirements apply to this division.
16. Pistons must be at least .009" in block.
17. Heads cannot vary more than 4 cc’s from stock. NO angle milling.
18. Protest any three (3) items (except bottom), $300. Bottom end $600, accepts fee $100, track retaining $100.
|
|
|
Posted by safefamilyvideo
|
|
|
|
|
|
|
|